A stability strap is available for this model.
Replacing an Earpad on the SRX2/SRX3 Hard-Hat or
High-Noise Headset
1. Remove the electronics module from the earcup.
2. Pry the earcup apart by grasping the inside and outside sections of the
earcup and pulling the two sections apart.
3. Remove the worn foam earpad from the inside plate.
4. Gently pull a new foam earpad around the plate.
5. Align the inside posts of the two sections of the earcup.
6. Push sections together until they click into place.
Options for Hearing Impaired Users
Honeywell products are designed for persons with average levels of hearing.
Operators who use assistive hearing devices may need to consider some
adjustments when using Honeywell headsets in a production warehouse
environment.
Honeywell recommends experimenting with combinations of several basic
changes to Talkman device operation to improve audibility:
l Change language voices using VoiceConsole (see VoiceConsole Online Help)
l Adjust the pitch of the voice lower or higher
l Adjust the volume of the voice louder or softer
l Adjust the speed of the voice slower or faster
l Change the gender of the voice to male or female
SRX3 User Guide - Preliminary 34
To Next Page
Loading...
Need help?
General
