Icon Status
The device is paired with a headset but not yet connected
The device is connected to the headset
Pairing a Headset by VoiceConsole Pairing
The
VoiceConsole
pairing method should only be used if the device/headset pairing will
be performed once and never changed. While manual pairing can also result in this per-
manent pairing,
VoiceConsole
eliminates the device inquiry step and begins paging
immediately for the Bluetooth address.
Prerequisites:
l The headset is powered off.
l The device is not in a charger, and there is no wired headset connected to it.
l The device is in sleep mode — not in use running an application.
l The device is Bluetooth ready with Bluetooth connection features enabled.
1. In VoiceConsole, click Devices and select the device for the pairing.
2. In Device Actions, select the actions for pairing to a peripheral, and
complete the pairing. See VoiceConsole help for detailed instructions.
TIP
The pairing can be performed with the device powered off or while the
device is running an application. When the device powers up or goes
into sleep mode, the paging process begins.
3. Place the headset in pairing mode. The SRX2 and SRX3 headsets are
automatically in pairing mode after being powered on.
4. When the two connect, the headset will play ascending connect tones. The
pairing confirmation step is skipped because the pairing was specified by
the user.
5. Press the Play/Pause button to begin working.
More about SRX2/SRX3 Pairing Modes
When a headset is in pairing mode it is ready to respond to any inquiries about
its Bluetooth services. The inquiring device uses this response to determine if it
wants to pair with the headset. Because the device is the initiator and the
headset is the acceptor, a user facilitates the pairing process by putting the
headset into pairing mode before initiating the connection from the device.
SRX2 and SRX3 headsets support three pairing modes.
SRX3 User Guide - Preliminary 44
To Next Page
Loading...
Need help?
General
