l This feature should ONLY be used for debugging and when a user requires
training or assistance. This parameter should be turned off for optimal
performance.
l Under normal operations, you cannot have a wired headset attached to the
device when using an SRX2 or SRX3 headset. This parameter overrides this
requirement when enabled.
l To avoid disconnecting the wireless headset, pair and connect the device to
the headset first, then connect a wired headset.
Headset Parameters
These parameters control various settings related to using headsets.
l Bluetooth_IsEnabled
l HeadsetBt_Address
l HeadsetBt_AuthenticationEnable
l HeadsetBt_DeviceName
l HeadsetBt_IsInitiator
l SrxHeadsetEnable
l SrxAutoPairEnable
l SrxClearPairingInCharger
l SRX_OUTPUT_AUDIO_DB_SHIFT
l SrxHighPowerPairingDelaySeconds
l SrxSupervisorAudioEnable
Cleaning Procedures for Honeywell Equipment
Honeywell Solutions products have a long service life if they are maintained
properly. Follow recommended cleaning practices.
While Honeywell equipment is manufactured and tested to be resistant to
normal dirt and deposits from the workplace environment, the build-up of
residue can damage the equipment and degrade performance over time.
l Dirt or corrosion can prevent the proper seating of terminals in chargers
and may cause intermittent charging.
l Talkman® Connector (TCO) contacts that build up dirt, chemicals, and
corrosion may cause intermittent contact, static, and recognition problems.
l Excessive dirt on a keypad membrane can cause the membrane to weaken
and tear.
CAUTION
Use only a solution of 70% isopropyl alcohol and water to clean
equipment. Other products have not been tested and may degrade the
equipment.
SRX3 User Guide - Preliminary 48
To Next Page
Loading...
Need help?
General
