30
Powering on the switch
Before powering on the switch, verify that the following conditions are met:
• The power cord is properly connected.
• The input power voltage meets the requirement of the switch.
• The console cable is properly connected.
• The configuration terminal (a PC, for example) has started, and its serial port settings are consistent
with the console port settings on the switch.
Power on the switch. During the startup process, you can access Boot ROM menus to perform tasks such
as software upgrade and file management. The Boot ROM interface and menu options differ with
software versions. For more information about Boot ROM menu options, see the software-matching
release notes for the device.
After the startup completes, you can access the CLI to configure the switch.
For more information about the configuration commands and CLI, see HP 5920 & 5900 Switch Series
Configuration Guide and HP 5920 & 5900 Switch Series Command References.
To Next Page
Loading...
Need help?
General
