11
− If they are configured correctly, go to step 2.
2. Verify that the ACL is configured correctly.
Execute the display acl command to check whether the ACL is configured correctly.
{ If the ACL is configured incorrectly, reconfigure it.
{ If the ACL is configured correctly, go to step 3.
3. If the problem persists, contact HP Support.
ACL used in a packet filter
To resolve the problem when the ACL is used in a packet filter:
1. Verify that the packet filter is configured correctly.
Execute the display packet-filter command to check whether the packet filter is configured
correctly.
{ If there are any configuration errors, reconfigure the packet filter.
{ If there is no configuration error, go to step 2.
2. Verify that the ACL is configured correctly.
Execute the display acl command to check whether the ACL is configured correctly.
{ If the ACL is configured incorrectly, reconfigure it.
{ If the ACL is configured correctly, go to step 3.
3. If the problem persists, contact HP Support.
Related commands
This section lists the commands that you might use for troubleshooting ACLs.
Command Descri
display acl Displays configuration and match statistics for ACLs.
display diagnostic-information
Displays operating statistics for multiple feature modules in
the system.
display packet-filter
Displays whether an ACL has been successfully applied to an
interface for packet filtering.
display qos-acl resource Displays QoS and ACL resource usage.
display qos policy control-plane
Displays information about the QoS policies applied to the
specified control plane.
display qos policy global Displays information about global QoS policies.
display qos policy interface
Displays information about the QoS policies applied to an
interface or to all interfaces.
display qos policy user-defined Displays user-defined QoS policies.
display qos vlan-policy Displays information about QoS policies applied to VLANs.
To Next Page
Loading...
Need help?
General
