Service Reference Guide, dc5000 360201-002 7–11
Removal and Replacement Procedures— Small Form Factor (SFF) Chassis
7.8 D r ives
The computer supports up to three drives.
This Section describes the procedure for replacing or upgrading the storage drives. A Torx T-15
screwdriver is needed to remove and install the guide screws on a drive.
Ä
CAUTION: Make sure personal files on the hard drive are backed up to an external storage device
before removing the hard drive. Failure to do so will result in data loss. After replacing the primary hard
drive, you will need to run the Restore Plus! CD to load the Compaq factory-installed files.
7.8.1 Drive Positions
To verify the type and size of the storage device installed in the computer, run Computer Setup.
Drive Positions
Item Description Item Description
1 One standard 3.5-inch,
one-third height bay (1.44-MB
diskette drive shown)*.
3 Internal 3.5-inch, one-third
height bay for hard drive
2 5.25-inch drive bay for
optional drives
*If the computer has a 1.44-MB diskette drive installed, it will be configured with a
diskette drive bezel as shown in the illustration. If the computer contains an empty
3.5-inch drive bay, then a bezel blank will be installed on the computer instead. If you
do not have a drive in this slot, you may choose to install a 3.5-inch device (such as a
diskette drive, hard drive, or Zip drive) later on. However, to install a 3.5-inch device
other than a diskette drive or hard drive, you must order the 3.5-inch device bezel to
provide proper air flow within the chassis.
To Next Page
Loading...
Need help?
General