HP DL360 Maintenance And Service Guide

Removal and Replacement Procedures
To replace the optical device:
1. Align the optical device with the optical device bay and slide the device into the chassis
until it is fully seated.
Figure 2-12: Aligning and installing the optical device
2. Press the Power/On Standby switch to power on the server, and resume normal
operations.
Optical Device Ejector
To remove the optical device ejector:
1. Power down the server. Refer to “Powering Down the Server” earlier in this chapter.
2. Remove the optical device. Refer to “Optical Device” earlier in this chapter.
3. Remove all hard drive blanks and hot-plug U320 SCSI hard drives. Refer to “Hard Drive
Blank” and “Hot-Plug U320 SCSI Hard Drives” earlier in this chapter.
4. Partially extend the server to gain access to the screws securing the optical device ejector
to the chassis.
HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide 2-15

HP DL360 Specifications

General

Brand	HP
Model	DL360
Category	Server
Language	English