HP DL360 Maintenance And Service Guide

Removal and Replacement Procedures
To replace the diskette drive:
1. Slide the diskette drive into the open bay (1).
2. Replace the diskette drive retaining screw (2).
Figure 2-18: Installing the diskette drive
3. Replace the hot-plug U320 SCSI hard drive. Refer to “Hot-Plug U320 SCSI Hard
Drives” earlier in this chapter.
4. Replace the access panel. Refer to “Server Access Panel” earlier in this chapter.
5. Replace the server in the rack. Refer to “Removing the Server from the Rack” earlier in
this chapter.
6. Connect the power cord(s).
7. Press the Power On/Standby switch to power on the server and resume normal
operations.
Hot-Plug Power Supplies
The procedures in this section assume that the server is configured with two power supplies.
To remove a power supply:
1. Disconnect the power cord.
HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide 2-19

HP DL360 Specifications

General

Brand	HP
Model	DL360
Category	Server
Language	English