HP DL360 Maintenance And Service Guide

Removal and Replacement Procedures
10. While holding the power converter, disconnect the power supply signal cable and the
system power cable from the system board.
Figure 2-31: Disconnecting the power supply signal cable and the
system power cable from the system board
Reverse steps 1 through 10 to replace the power converter module.
Optical Device/Diskette Drive Interface Board
To remove the optical device/diskette drive interface board:
1. Power down the server. Refer to “Powering Down the Server” earlier in this chapter.
2. Remove the server from the rack. Refer to “Removing the Server from the Rack” earlier
in this chapter.
3. Remove the access panel. Refer to “Server Access Panel” earlier in this chapter.
4. Remove the optical device and diskette drives. Refer to “Optical Device” and “Diskette
Drive” earlier in this chapter.
2-28 HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide

HP DL360 Specifications

General

Brand	HP
Model	DL360
Category	Server
Language	English