108
# Bind VFC 2 to interface Ten-GigabitEthernet 1/0/2.
[FCF-vfc2] bind interface ten-gigabitethernet 1/0/2
[FCF-Vfc2] quit
# Configure Ten-GigabitEthernet 1/0/2 as a trunk port, and assign the port to VLAN 10.
[FCF] interface ten-gigabitethernet 1/0/2
[FCF-Ten-GigabitEthernet1/0/2] port link-type trunk
[FCF-Ten-GigabitEthernet1/0/2] port trunk permit vlan 10
[FCF-Ten-GigabitEthernet1/0/2] quit
# Enable FCoE for VLAN 10 and map VLAN 10 to VSAN 10.
[FCF] vlan 10
[FCF-vlan10] fcoe enable vsan 10
Verifying the configuration
# Display ENode information obtained by the Transit switch.
[Transit] display fip-snooping enode
VLAN 10:
Interface ENode WWN ENode MAC
XGE1/0/1 10:00:00:11:22:00:0d:01 0000-1234-0d01
# Display FCF switch information obtained by the Transit switch.
[Transit] display fip-snooping fcf
VLAN 10:
Interface FCF MAC FCF WWN Fabric Name ENode
XGE1/0/2 0000-1234-0e01 10:00:00:11:22:00:0e:01 10:0a:00:11:22:00:0e:01 1
# Display information about FIP snooping sessions.
[Transit] display fip-snooping sessions
VLAN 10:
FCF MAC ENode MAC VN_Port MAC VN_Port WWN
0000-1234-0e01 0000-1234-0d01 0efc-0001-0000 af:10:01:11:22:00:0d:01
# Display the FIP snooping rules that have been flushed.
Slot 1:
VLAN 10:
FCF rules information:
Interface Source MAC/Mask Destination MAC/Mask Context
XGE1/0/2 0000-1234-0e01/48 0efc-0000-0000/24 ffffffff
ENode rules information:
Interface Source MAC/Mask Destination MAC/Mask Context
XGE1/0/1 0efc-0001-0000/48 0000-1234-0e01/48 ffffffff
To Next Page
Loading...
Need help?
General