HP FlexFabric 5700 series Configuration Guide

81
Ste
p
Command Remarks
2. Enter VSAN view.
vsan vsan-id N/A
3. Configure a zoning mode.
• Enable the enhanced zoning
mode:
zone mode enhanced
• Enable the basic zoning mode:
undo zone mode enhanced
By default, the basic zoning mode is
enabled.
Configuring the Pairwise feature
This feature can be configured only in enhanced zoning mode.
This feature allows a member to access only members with a different role in the same zone. A member
with both roles can access both initiator members and target members.
After you disable this feature for a zone, all members in the zone can access each other, regardless of
member roles.
Both basic zoning and enhanced zoning support this feature.
To configure the Pairwise feature:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VSAN view.
vsan vsan-id N/A
3. Enter zone view.
zone name zone-name N/A
4. Configure the Pairwise
feature.
• Enable the Pairwise feature:
pairwise-zoning enable
• Disable the Pairwise feature:
undo pairwise-zoning enable
By default, the Pairwise feature is
disabled.
Configuring zone aliases
You can configure a maximum of 4000 zone aliases for all VSANs on a switch.
You can specify members of a zone alias by using their FC addresses, pWWNs, or fWWNs. An fWWN
is the WWN of an F_Port. An F_Port member represents all N_Ports that log in through the F_Port. Any
specified N_Port members can be indirectly connected to the switch.
You can specify the role of a member as an initiator, a target, or both when adding the member. The role
can be configured only in enhanced zoning mode and takes effect only when the Pairwise feature is
enabled.
To configure a zone alias:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VSAN view.
vsan vsan-id N/A

HP FlexFabric 5700 series Specifications

General

Brand	HP
Model	FlexFabric 5700 series
Category	Switch
Language	English