To do… Use the command… Remarks
Configure the source IP address of
FTP request packets
source ip ip-address
Required
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no FTP requests can be
sent out.
Configure the operation type operation { get | put }
Optional
By default, the operation type for
the FTP is get, which means
obtaining files from the FTP server.
Configure a login username username name
Required
By default, no login username is
configured.
Configure a login password password password
Required
By default, no login password is
configured.
Specify a file to be transferred
between the FTP server and the FTP
client
filename file-name
Required
By default, no file is specified.
Set the data transmission mode for
FTP tests
mode { active | passive }
Optional
active by default.
Configure optional parameters
See “Configuring optional
parameters for an NQA test
group”
Optional
NOTE:
• When you execute the put command, the NQA client creates a file
named
file-name
of fixed size on the
FTP server. The
file-name
argument does not represent any file on the NQA client. When you execute the
get command, the client does not save the files obtained from the FTP server.
• When you download a file that does not exist on the FTP server, the FTP test fails.
• When you perform an FTP test, use a small file and set a long NQA probe timeout time. A big file or
short probe timeout time may result in probe timeout.
Configuring HTTP tests
HTTP tests of an NQA test group are used to test the connection between the NQA client and an HTTP
server, and the time required to obtain data from the HTTP server. HTTP tests enable you to detect the
connectivity and performance of the HTTP server.
Configuration prerequisites
Before you start HTTP tests, configure the HTTP server.
Configuring HTTP tests
Follow these steps to configure HTTP tests:
16
To Next Page
Loading...
Need help?
General
