Configuring the Switch Modules using the Menu-driven Interface
Configuring Port Security
To configure security for a specified port or range of ports on the switch module:
1. Highlight Configure Port Security on the Configuration menu.
2. Press the Enter key. The following screen is displayed.
3. Toggle the View Ports field to the port range that you want to view.
4. Type the port number or range of numbers to configure in the Configure Port fields.
5. Toggle the Admin State field to Enabled to enable port security on the ports.
6. Type a number between 1 and 10 in the Max. Addr. field to set the maximum number of
addresses that can be learned.
7. Toggle to the mode that you want in the Mode field: DeleteOnReset or
DeleteOnTimeout.
8. Highlight APPLY.
9. Press the Enter key.
IMPORTANT: To save the configuration settings permanently, you must enter them into NVRAM
using the Save Changes option on the main menu. Refer to the “Saving Changes” section earlier
in this chapter.
HP ProLiant BL e-Class C-GbE Interconnect Switch Menu-driven Interface Reference Guide 2-43
HP CONFIDENTIAL Codename: DeLorean Part Number: 322858-001 Last Saved On: 2/4/03 11:56 AM
To Next Page
Loading...
Need help?
General