Configuring the Switch Modules using the Menu-driven Interface
5. Type the path and the filename to the firmware file on the TFTP server in the
Path\Filename field.
IMPORTANT: The TFTP server must be running TFTP server software to perform the file transfer.
TFTP server software is included in many network management software packages, or it can be
obtained as part of the interconnect switch utilities package.
6. Highlight APPLY.
7. Press the Enter key to record the IP address of the TFTP server.
8. Highlight START.
9. Press the Enter key to initiate the file transfer.
IMPORTANT: To save the configuration settings permanently, you must enter them into NVRAM
using the Save Changes option on the main menu. Refer to the “Saving Changes” section earlier
in this chapter.
IMPORTANT: A downloadable smart component, which further simplifies upgrading the switch
module firmware, is available at the following website:
www.compaq.com/support/servers
Downloading Configuration File from a TFTP Server
IMPORTANT: Configuration files used in the earlier version of the interconnect switch (firmware
version 1.0) are not supported by the present version (firmware version 2.0). The switch module
Information window displays the firmware version.
A configuration file can be downloaded from a TFTP server to the switch module. This file is
then used by the switch module to configure itself. Beginning in firmware version 2.0.0,
switch firmware configuration files are specified in XML format.
Downloaded XML configuration files do not need to specify every possible parameter. Only
the configuration parameters specified will be modified; others will remain unchanged.
To download a switch module configuration file from a TFTP server:
1. Highlight Use a Configuration File on TFTP Server on the Switch Utilities menu.
2-60 HP ProLiant BL e-Class C-GbE Interconnect Switch Menu-driven Interface Reference Guide
HP CONFIDENTIAL Codename: DeLorean Part Number: 322858-001 Last Saved On: 2/4/03 11:56 AM
To Next Page
Loading...
Need help?
General