FUP Commands
File Utility Program (FUP) Reference Manual—523323-014
2-198
VOLS
VOLS
Displays information about volumes on a system. The VOLS command lists the
names, capacities, and current usage for all specified volumes in a format that is
similar to the Disk Space Analysis Program (DSAP) utility.
OUT listfile
names an existing disk file or a device to receive the listing output from the VOLS
command. You can use either a standard file name or a spool DEFINE name as
the OUT listfile for a VOLS command. If listfile is an existing file, FUP
appends the output to that file.
volset
specifies volumes to display information about. The volset parameter can be the
name of a volume or a wild card, and it can include a system name. If you specify
a volume name, it must begin with a dollar sign ($). The default is all volumes on
the current system ($*).
VOLS Example
To show information on all volumes of the current system that begin with the letter M:
-VOLS $M*
-- Capacity (Mb) -- % -- Free Extents --
Volume (M) Total Free Free Count Biggest
$MCAT Y 895 346.62 38 12 332.24
$MOLD Y 415 50.04 12 25 26.67
$MONO 895 289.97 32 125 287.74
$MONO1 895 314.41 35 1 314.41
$MOSS Y 415 150.09 36 491 66.67
VOLUME
Changes the current default volume or subvolume names used during the execution of
FUP. The initial defaults are the subvolume and volume that were the current defaults
when you started FUP.
VOLS [ / OUT listfile / ] [ volset ]
volset is:
[ \node.] $volume
Note. For more information about listfile, see Specifying Files on page 1-8.
VOLUME [ [\node.] $volume [.subvol ] ]
[ [\node.] subvol ]
To Next Page
Loading...
Need help?
General