FUP Commands
File Utility Program (FUP) Reference Manual—523323-014
2-13
ALTER Parameters for Files With Alternate-Key
Fields
[ NO ] SERIALWRITES
sets the mode of writes to the mirror: serial or parallel. The default is NO
SERIALWRITES.
[ NO ] VERIFIEDWRITES
sets the mode of file writes: verified or unverified. The default is NO
VERIFIEDWRITES.
ALTER Parameters for Files With Alternate-Key Fields
These alter-option parameters are available for files with alternate-key fields:
ALTFILE ( key-file-number, filename )
adds or replaces the file name of an alternate-key file. You must include this
parameter for any undefined key file number referenced by an ALTKEY
specification. To designate the alternate-key file being named, specify
key-file-number as an integer in the range 0 through 255.
The FUP process expands a partial file name by adding the current default names
for node, volume, and subvolume.
If you add a new ALTFILE number, your ALTER command must also include an
ALTKEY option that specifies the alternate-key file.
If you define a new alternate-key file, you must create the file in a separate
operation either before or after using ALTER ALTFILE.
If you delete the last alternate-key specification, you must also delete the
corresponding alternate-file specification in the same ALTER command.
If you delete the last alternate-file specification, you must also delete the
corresponding alternate-key specification in the same ALTER command.
ALTKEY ( key-specifier { , altkey-param }... )
adds, replaces, or alters an alternate-key specification.
key-specifier
is a 2-byte value that identifies this alternate-key field. Specify
key-specifier as either a one or two-character string in quotation marks:
"[c1]c2"
or as an integer from -32,768 through 32,767:
{ -32,768 : 32,767 }
To Next Page
Loading...
Need help?
General