6
6-17
(Drive) while the function is on. i-PEDAL
is disabled and regenerative braking
level is set to 3.
CAUTION
• Depending on the vehicle and road
condition, the vehicle may not come to
a stop although the i-PEDAL function is
active. Check surroundings and
depress the brake pedal to control the
vehicle speed.
• Do not use i-PEDAL on slippery roads.
i-PEDAL limitations
In the following conditions, the vehicle
may not come to a stop although the
i-PEDAL is properly activated. Depress
the brake to stop the vehicle when:
• Driving on a slope, or when the vehicle
is repeatedly driven and stopped.
• The vehicle is driving through the end
of the slope.
• Driving on a slippery surface such as an
icy, rainy, or muddy road.
• The wheels are not properly aligned.
• A wheel slip or wheel spin occurs.
• The weight on board is heavy.
• The vehicle is tilted to the side.
• The tire is worn out.
Smart Regeneration
System
The smart regeneration system
recognizes vehicle-to-vehicle distance,
road gradient, and speed cameras and
controls the regenerative braking level
while coasting. It reduces unnecessary
depressing of pedals to improve fuel
efficiency and driver convenience.
Information
• Coasting is the process of driving a vehicle
without the brake pedal and the accelerator
depressed. Coasting uses the inertia of
driving energy instead of the vehicle power.
• The regenerative braking system uses the
electric motor to engage the brake. The
electric motor converts the kinetic energy
generated from decelerating the vehicle to
electricity and charges the high voltage
battery.
Smart Regeneration System
On/Off
Operate the paddle shifter as shown
below to use the smart regeneration
system.
• Turning on the smart regeneration
system: While the indicator is on,
shift the gear to D (Drive), and pull and
hold the right paddle shifter ( ) for
over a second.
Hyundai_CE_en_US.book Page 17
To Next Page
Loading...
Need help?
General
