7. Push the power supply unit back into the enclosure until the handle starts to
move.
8. Finish inserting the power supply unit into the enclosure by closing the
handle until the locking catch clicks into place.
9. Reattach the power cable and cable retention bracket.
10. Turn on the power switch to the power supply unit.
If required, return the power supply. Follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Replacing a power supply unit for an expansion enclosure
You can replace either of the two 580 watt hot-swap redundant power supplies in
the expansion enclosure. These redundant power supplies operate in parallel, one
continuing to power the canister if the other fails.
Chapter 5. Control enclosure 217
To Next Page
Loading...
Need help?
General