Figure 114. The hex wrench rewinds tape into cartridge
6.
Turn the supply reel clockwise, allowing the moistened tape to adhere to the hub as it winds around
the supply reel (inside the cartridge).
7. Continue spooling into the cartridge until the tape is taut and remains within the flanges of the tape
guiding rollers. Ensure that you do not stretch the tape.
8. Go to “Ending procedure” on page 245
.
Half height driv
e: Tape spooled off supply reel
Before you begin
Attention: DO NOT TOUCH THE OUTER GUIDE RAIL (2). THIS RAIL IS DELIC
ATE AND EASILY
DAMAGED.
About this task
Note: If the cartridge in the drive is an INPUT tape that contains ACTIVE or 'ONLY COPY' data (there is no
backup), eject commands that are issued at the host fail to unload the tape, and power-cycling the drive
fails to eject the cartridge, make no further attempts to unload this tape. Call Technical Support and open
a PMR if one is not already open, to initiate the process of sending the drive with the loaded cartridge in
for recovery.
Procedure
1. From the takeup reel, pull an arm's length of tape around the rear of the tape path and over the head
and rollers on the left side of the drive.
2. Set the drive on its left side with the head and tape path facing up.
3. Ensure that the tape is not twisted. Untwist the tape if required.
4. Moisten a cotton swab with water and wet approximately 13 mm (0.5 in.) of the tape end and feed it
onto the supply reel (inside the cartridge).
IBM Condential
228IBM T
S4300 Tape Library Machine Type 3555: User's Guide
To Next Page
Loading...
Need help?
General
