Figure 122. The hex wrench rewinds tape into cartridge
3. From the bottom of the drive, locate the access hole (1 in Figure 122 on page 236).
4. Insert a 2.5 mm offset hex wrench through the bottom cover access hole and into the reel motor axle.
Begin spooling the tape back into the cartridge by turning the hex wrench clockwise.
5. Continue spooling into the cartridge until the tape is taut and remains within the flanges of the tape
guiding rollers. Ensure that you do not stretch the tape.
6. Locate the threader motor worm gear (4 in Figure 123 on page 237) on the rear of the drive. Use
your îš´nger to rotate the treader motor worm gear and slowly rotate the threader mechanism gear
(6 in Figure 123 on page 237) clockwise.
This action rotates the threader motor worm gear (4 in Figure 123 on page 237) clockwise, drawing
the LBA into the cartridge.
IBM Conîš´dential
236IBM TS4300 Tape Library Machine Type 3555: User's Guide
To Next Page
Loading...
Need help?
General
