4. Check that all components for assembling the module are in the box. See “Identifying Library Module
components” on page 50.
Figure 26. The module after removal from the box
Attention: Do not place a module on either the ends or sides as this action can damage the
module.
Identifying Library Module components
Use the packing slip that is included with your module to identify the module components.
The TS4300 model 3555 is not shipped with a rack mount kit (IBM FC: 7002) and/or power cord (IBM FC:
9800-9848) unless it is ordered.
1. Locate one or more packing slips for your module.
2. Verify that you received each item that is listed on the packing slips.
Note: Order the power cord that matches the electrical requirements of the country or area. Power cord
FC 9848 must be ordered with the rack mount kit if a rack-based power supply is used.
For SAS libraries, you must provide SAS cabling with the correct conguration for your HBA. For Fibre
Channel libraries, you must provide one Fibre Channel cable for each tape drive. See “Optional features”
on page 45.
Installing a tabletop module
Installation of a one module library (Base Module only) can be completed without special hardware.
Before you begin
When unpacking a tabletop module, conrm that you received the following components:
1. Base Module
2. Power cord (IBM FC: 9800-9848 are not a part of the shipment unless ordered. For more information
see, “Optional features” on page 45.)
3. Feet kit
IBM Condential
50IBM TS4300 Tape Library Machine Type 3555: User's Guide
To Next Page
Loading...
Need help?
General
