Draco tera
184 2020-02-26
8. If you have created a Cascade CPU Unit, select Extender & Devices
> CPU Devices in the task area of the Master Matrix and press the
New Device button.
A switchable CPU Device will be created.
9. Enter an appropriate extender name into the Name field.
10. Assign the previously configured Extender Unit to the just created
Device by moving the Extender Unit from the Extender available
field into the Extender assigned field and save your settings by
pressing the Apply button.
11. Connect to the Sub Matrix and repeat steps 1 to 10.
12. Select System Settings > System in the task area of the Sub Matrix
and activate the Sub Matrix option.
The OSD of the Sub Matrix will immediately freeze and will be only
accessible by using the keyboard command <'Hot Key'>, <s>, <o>.
13. Restart all I/O boards on which any Master/Sub CON or CPU Units
have been configured or alternatively restart the matrix.
14. Connect the Tie Lines to the matrices. Ensure that each Cascade
CON on one matrix is connected to Cascade CPU on the other matrix
in order to achieve switchability between two matrices.
The Matrix Cascading is now configured and can be used. Additional Tie
Lines are configured accordingly. The use of cascading is described in
Chapter 6.1.4, Page 207.
Pos: 106 /806-IHS E/Konfiguratio n/480_Matrix/M atrix-Grid @ 10\mod_1389 091114008_6.d oc @ 113198 @ 2 @ 4
To Next Page
Loading...
