Ihse K480-288 User Manual

Draco tera
232 2020-02-26
Pos: 139 /806-IHS E/Betrieb/Ei n- und Ausschaltf unktionen/ 480-xx/Factory Res et @ 7\mod_ 13099410817 74_6.doc @ 536 38 @ 3 @ 1
6.13.2 Factory Reset
You have the following option to perform a reset of the system:
If you perform a (factory) reset, all current settings and all configurations
stored in the matrix will be lost. This also applies to the network
parameters (reset to DHCP) and the admin password.
If a firmware update has been installed since the delivery, the matrix will
be set to the state defined there.
OSD
1. Select Configuration > Factory Reset in the main menu.
2. Confirm the selection with the Okay button.
The matrix will be reset to factory settings.
Pos: 140 /806-IHS E/Betrieb/Ei n- und Ausschaltf unktionen/ 480-xx/480_Auss chalten @ 7\m od_1310646450 471_6.doc @ 5 4300 @ 3 @ 1
6.13.3 Power Down
You have the following option to perform a shut down of the system or
single components:
OSD
In order to shut down the system, proceed as follows:
1. Select Configuration > Shut down Matrix in the main menu.
2. Confirm the selection with the Okay button.
The matrix will be shut down.
The fans will be switched to maximum speed after the shut down.
Then the matrix can be disconnected from the power supply.
In order to shut down an I/O board, proceed as follows:
1. Select Configuration > Shut Down IO Board in the main menu.
2. Confirm the selection with the Okay button.
The I/O board will be shut down.
Pos: 141 /806-IHS E/Betrieb/48 0_Zusammenfass ung Tastaturk ommandos/48 0_Zusammenf assung Tastatur Kommandos @ 9\mod_136 0601486169_ 6.doc @ 7109 2 @ 2 @ 1

Ihse K480-288 Specifications

General

Brand	Ihse
Model	K480-288
Category	Switch
Language	English