Draco tera
54 2020-02-26
The default IP address is 192.168.100.99 and DHCP is deactivated.
When installaing several matrices at the same time, it is strongly
recommended to install them in sequence and to assign unique IP
addresses in order to avoid IP address conflicts.
Setup of Extender
1. Connect the CON Units to the matrix by using the interconnect cables
(Cat X or fiber).
2. Connect the CON Units to the input devices to be used (for example
keyboard and mouse).
3. Connect the 5VDC power supply units to the CON Units.
4. Check the basic function of the CON Unit by opening the OSD via
keyboard command <'Hot Key'>, <o>.
5. Connect the source (computer, CPU) to the CPU Unit of the extender
by using the provided connection cables.
6. Connect the CPU Unit to the matrix using the interconnect cables
(Cat X or fiber).
7. If you have a video matrix, connect the video source directly to the
matrix using the interconnect cables (coax, fiber).
8. Connect the 5VDC power supply units to the CPU Units.
9. Start the system.
Pos: 43 /806-IHSE/ Installation/In stallationsbeispi ele/UEB_Inst allationsbeispiele _480-xx @ 7\mod_13113 38893738_6.doc @ 54459 @ 2 @ 1
4.3 Example Applications
The Draco tera supports a wide and flexible range of system
configurations:
Pos: 44 /806-IHSE/ Installation/In stallationsbeispi ele/480-xx/I nstallationsbeis piele @ 7\m od_130993617083 6_6.doc @ 527 91 @ @ 1
A part of the Draco tera can be configured as a Single-Head work station,
a part as Dual-Head, as Quad-Head or even as a video matrix for
example. In addition there are configurations with KVM and USB 2.0
available.
In addition to OSD access by a keyboard connected to the CPU board or
an extender CON Unit, other methods of control are available, including:
Java Tool
Serial interface
A connection to common media controls is also possible.
To Next Page
Loading...
Need help?
General
