Draco tera
222 2020-02-26
You can select the following switching operations:
<current 'Hot Key'>,
<Num 0>
Switching of the USB-HID signal to the own
display (CON Unit with keyboard and mouse)
<current 'Hot Key'>,
<Num 1>
Switching of the USB-HID signals to display #1
<current 'Hot Key'>,
<Num 2>
Switching of the USB-HID signals to display #2
<current 'Hot Key'>,
<Num 3>
Switching of the USB-HID signals to display #3
<current 'Hot Key'>,
<Num 4>
Switching of the USB-HID signals to display #4
Pos: 129 /806-IHS E/Betrieb/US B-2.0-Umsch altung/480_US B-2.0-Umschaltu ng @ 8\mod_ 134579445567 2_6.doc @ 68 043 @ 2 @ 4
6.8 USB 2.0 Switching
Switching of USB 2.0 extender basically works like switching of KVM
extenders. The following scenarios to switch USB 2.0 extenders are
possible.
1. An extender unit with USB 2.0 will be created and assigned to an
already existing device with existing KVM extender units (see Chapter
5.10, Page 132 or Chapter 5.13.1, Page 140).
2. A separate device for the extender unit with USB 2.0 will be created
without assigning a KVM extender unit to that device. This possibility
offers a separate switching of the USB 2.0 signal (see Chapter 5.10,
Page 132 or Chapter 5.13.1, Page 140).
Switching of USB 2.0 signals uses Extended Switching functionality (see
Chapter 6.3, Page 211).
When using parallel operation within the matrix, set the Release Time in
the System Settings > Switch menu to 10 s or more (see Chapter
5.13.6, Page 158). Otherwise the connection of the USB 2.0 extender will
not be established due to security and stability reasons.
Pos: 130 /806-IHS E/zz_Layout/ Seitenumbruch @ 8\mod_134 8581820516_ 0.doc @ 69462 @ @ 1
To Next Page
Loading...
Need help?
General
