Function and Features
3.5 Switching Setting Value and Actual Value
[Meter] button is used to switch the display between actual value and setting
value. When [Meter] button is lit, this represents that VFD board display is
actual value. Reversely, if [Meter] button is dark, VFD board display is
corresponding to setting value.
This option allows users to enable an internal fixed timer delay (5 seconds) for
the power supply to automatically switch from setting display to measured
display. When enabled, if the power supply output state is ON (enabled) and if
the display shows setting voltage and current, it will automatically switch to
measured voltage and current display after 5 seconds. Factory default is Off
status.
3.6 Switching Local/Remote Mode
Power supply provides local and remote modes. The two modes can be
switched through communication commands. The default setting is local mode.
• Local mode: use press keys on the power supply front panel to operate.
• Remote mode: connect the power supply with PC, and operate power
supply through PC. When it’s remote mode, only [On/Off], [Meter],
[Shift]+[Meter] (Local) work, with all the other panel keys not working. It can
be switched to local mode by [Shift]+[Meter] (Local) . The power supply’s
output parameters won’t be influenced when mode is switched.
3.7 Key Lock Function
[Shift]+[On/Off] (Lock) button can enable you to lock the front panel buttons,
then VFD will display “*”. In keylock mode, all buttons will not work except for
[On/Off], [Meter] and [Shift] buttons. Re-press [Shift]+[On/Off] (Lock) button
will release the keylock function.
3.8 Save/Recall Operation
IT6500C can enable you to save some frequently-used parameters in
nonvolatile memory up to 100 sets, so that you can recall the parameters
quickly. The following ways can help you achieve the save and recall
operations: by pressing composite button [Shift] +[Recall] (Save) button or
Copyright © Itech Electronic Co., Ltd.
21
To Next Page
Loading...
Need help?
General
