To Next Page

To Previous Page

Remote Control

6. After setting, press [Esc] to exit.

4.4.1 Using the Web Interface

The instrument has a built-in Web interface for monitoring and controlling the in-

strument via a Web browser. To use the Web interface, connect the instrument

and PC over LAN and enter the instrument's IP address into the address bar at

the top of your PC's Web browser, you can access the front panel control func-

tions including the LAN configuration parameters.

• Please confirm the IP address and Gateway is configured correctly. The detailed

information refer to the Configure LAN Interface Information.

• You must enable Web service if you wish to remotely control your instrument us-

ing its built-in Web interface. Refer to LAN services setting for the detailed oper-

ation procedures.

• Up to six simultaneous connections are allowed. With additional connections,

performance will be reduced.

As shipped, the login password of the Web interface defaults to 12345678. To

change the password, click the Security button in the navigation bar on the left

side of the window after login.

Enter the password and then click the LOGIN button, the Web Interface will ap-

pear in the browser as shown below. The following figure is just as an example

and the Web interface of different models are different. The actual shown page

shall be subject to the connected instrument.

ITech IT6500C Series User Manual

Other manuals for ITech IT6500C Series