Remote Control
6. se left and right keys or rotate the voltage knob to select the desired
service, and press [Enter]key to confirm.
User need to set the Socket Port when select enable the Raw Socket.
7. Rotate the knob to adjust the value, and press [Enter]key to confirm.
– On: indicates enable the service.
– Off: indicates disable the service.
8. After setting, press [Esc] to exit.
Reset the LAN to the Default Settings
The operation steps to reset the LAN to the default settings are as follows.
1. Press [Shift]+[P-set](Menu) to enter into the system menu interface.
2. se left and right keys or rotate the voltage knob to select SYSTEM and press
[Enter]key enter to system menu.
3. se left and right keys or rotate the voltage knob to select Communication，
and press [Enter]key to confirm.
4. se left and right keys or rotate the voltage knob to select LAN，and press
[Enter]key to confirm.
5. se left and right keys or rotate the voltage knob to select Restore，and
press [Enter]key to confirm.
• NO: indicates refuse to reset the LAN to the default settings.
• YES: indicates reset the LAN to the default settings.
6. After setting, press [Esc] to exit.
Confirm the LAN Setting
After configuring the LAN settings, the user need to confirm the settings to
make it valid in the instrument. The operation steps to confirm the LAN settings
are as follows.
1. Press [Shift]+[P-set](Menu) to enter into the system menu interface.
2. se left and right keys or rotate the voltage knob to select SYSTEM and press
[Enter]key enter to system menu.
3. se left and right keys or rotate the voltage knob to select Communication，
and press [Enter]key to confirm.
4. se left and right keys or rotate the voltage knob to select LAN，and press
[Enter]key to confirm.
5. se left and right keys or rotate the voltage knob to select Reset，and press
[Enter]key to confirm.
• NO: indicates refuse to confirm the LAN setting.
• YES: indicates confirm the LAN setting.
Copyright © Itech Electronic Co., Ltd.
88
To Next Page
Loading...
Need help?
General
