3.2 Preparing the truck for operation
Switching on the truck
Requirements
– Checks and operations to be performed before starting daily work, see page 67.
Procedure
• Pull the emergency disconnect switch (18) to unlock it.
• To switch on the truck:
• Insert the key in the key switch (2) and turn it as far to the right as it will go.
•
Enter the code in CanCode (o) (14) or using the soft keys under the display
unit (2-inch display) (o).
• Hold the card or transponder in front of the ISM access module and, depending
on the setting, press the green button on the ISM access module (o).
Z
The tiller (12) must be in the upper braking zone "B". If event message "E-0914" is
displayed on the CanDis display instrument (o) or on the display unit (2-inch
display) (o), move the tiller to the upper brake zone "B", see page 80.
The truck is ready for operation.
t The charge status indicator (1) shows the current battery charge status.
o The CanDis display instrument (62) or the display unit (2-inch display) shows the
current battery charge status and the service hours.
68
04.19 en-GB
To Next Page
Loading...
Need help?
General
