4.4 Travel
WARNING!
Collision hazard when operating the truck
Collisions with personnel and equipment can result if the truck is operated with open
panels.
u
Do not operate the truck unless the panels and covers are closed and properly
locked.
u
When travelling through swing doors etc. make sure that the doors do not activate
the collision safety button.
Requirements
– Start up the truck, see page 67.
Procedure
• Set the tiller (12) to the travel zone (F).
• Control the travel direction with the travel switch (9):
• Rotate the travel switch (9) slowly in the load direction (3):
Travel in load direction:
• Rotate the travel switch (9) slowly in the drive direction (2):
Travel in drive direction:
• Control the travel speed with the travel switch (9):
• The further the travel switch (9) is rotated, the greater the travel speed.
• Control the travel speed by rotating the travel switch (9) further or less.
Z
After releasing the travel switch (9), it automatically returns to the neutral position
(0), and the truck brakes.
The brakes are released and the truck moves in the selected direction.
Anti-roll back device for slow travel on inclines
If the truck does not have sufficient speed to travel up an incline, it may roll back.
Rolling back is detected by the truck's controller and the truck brakes to a halt
immediately.
76
04.19 en-GB
To Next Page
Loading...
Need help?
General
