5.1 Truck does not start
Possible cause Actions
Battery connector not plugged in Check the battery connector
and connect if necessary
Emergency disconnect switch pressed Release the emergency disconnect switch,
see page 73
Key switch in position "O" Set the key switch to position "I"
Battery charge too low Check battery charge and
charge the battery if necessary
Faulty fuse Check the fuses, see page 179
Incorrect ISM access module (o)
transponder used
Use correct transponder
Incorrect code entered in CanCode (o)
or using the soft keys under the display
unit (2-inch display) (o)
Enter correct code, see page 106
"Raise load handler" button/"Lower
load handler" button not in home
position when truck switched on (for
CanDis (o) or the display unit (2-inch
display) (o), event message E-2951
appears)
Do not actuate the button
Travel switch not in home position
when truck switched on (for CanDis
(o) or the display unit (2-inch display)
(o), event message E-1901 appears)
Do not actuate the travel switch
Collision safety switch actuated when
truck switched on (for CanDis (o) or
the display unit (2-inch display) (o),
event message E-1914 appears)
Do not actuate the collision safety switch
"Slow travel" button actuated when
truck switched on (for CanDis (o) or
the display unit (2-inch display) (o),
event message E-1901 appears)
Do not actuate the button
96
04.19 en-GB
To Next Page
Loading...
Need help?
General
