8.8 General Information about the Use of Keyless Access Systems
The default code is to be found on a sticker. When using the truck for the first time,
change the set-up code and remove the sticker!
– Default code: 1-2-3-4
– Factory set-up code: 2-4-1-2
Z
When allocating the codes, ensure the rider trucks are given a different code than
pedestrian trucks.
Z
When a valid code is entered or a valid transponder used, a green tick appears in
the display unit.
When an invalid code has been entered or a invalid transponder used, a red cross is
displayed, and the entry must be repeated.
Z
If the truck is not used for a certain length of time, the display unit switches to
standby mode. Pressing any key cancels the standby mode.
The following additional settings can be performed by the manufacturer’s customer
service department.
8.9 Commissioning the Keypad and the Transponder Reader
If the truck is equipped with a keypad or a transponder reader, it can only be
operated using the keys in the display unit. The keypad and the transponder reader
have to be activated by the operating company.
150
04.19 en-GB
To Next Page
Loading...
Need help?
General
