3 Using the Truck for the First Time
WARNING!
The use of unsuitable energy sources can be hazardous
Rectified AC current will damage the assemblies (controllers, sensors, motors etc.)
of the electronic system.
Unsuitable cable connections (too long, insufficient wire cross-section) to the battery
(tow cables) can overheat, setting the truck and battery on fire.
u
The truck must only be operated with battery current.
u
Cable connections to the battery (tow leads) must be less than 6 m long and have
a minimum cross-section of 50 mm².
Procedure
• Check the equipment is complete.
• If necessary, install the battery, see page 56.
• Charge the battery, see page 48.
The truck can now be started, see page 72.
NOTICE
Do not lift loads if the truck is operated via a tow lead with an external battery.
NOTICE
Cold store trucks
u
Trucks designed for use in cold stores have a cold store hydraulic oil and a
protective frame instead of a mast guard on the mast.
u
If a truck with cold store oil is used outside the cold store, the lowering speeds
may increase.
CAUTION!
Poor visibility through the protector
The mast protection pane protector can impair the operator's visibility.
u
Remove the protector (transport retainer) from both sides of the mast protection
pane.
Wheel flattening
If the truck has been parked for a long period, the wheel surfaces may tend to
flatten. This flattening has a negative effect on the safety and stability of the truck.
Once the truck has covered a certain distance, the flattening will disappear.
42
04.19 en-GB
To Next Page
Loading...
Need help?
General
