Jungheinrich ERE Series - Lateral Battery Removal

D 5
0709.GB
5.2 Lateral Battery Removal (o)
F
The truck must be level. To prevent short
circuits, batteries with exposed terminals or
connectors must be covered with a rubber mat.
Place the battery connector or the battery cable
in such a way that they will not get caught on the
truck when the battery is removed.
Battery removal
– Expose the battery (see Section 3).
– Remove the battery connector (3).
– Turn the battery lock (9) as far as the stop.
– Pull the battery out from the side.
Battery installation
M
Installation is the reverse order. When
reinstalling the battery, note the proper
installation position and make sure the battery
is connected correctly.
– After installing the battery again, check all
cables and plug connections for visible signs
of damage.
F
Close the battery panel carefully and slowly.
Do not reach between the battery panel and the
chassis.
9
9
D 5
0709.GB
5.2 Lateral Battery Removal (o)
F
The truck must be level. To prevent short
circuits, batteries with exposed terminals or
connectors must be covered with a rubber mat.
Place the battery connector or the battery cable
in such a way that they will not get caught on the
truck when the battery is removed.
Battery removal
– Expose the battery (see Section 3).
– Remove the battery connector (3).
– Turn the battery lock (9) as far as the stop.
– Pull the battery out from the side.
Battery installation
M
Installation is the reverse order. When
reinstalling the battery, note the proper
installation position and make sure the battery
is connected correctly.
– After installing the battery again, check all
cables and plug connections for visible signs
of damage.
F
Close the battery panel carefully and slowly.
Do not reach between the battery panel and the
chassis.
9
9