To Next Page

To Previous Page

1113.GB

E 20

5.5 Travel parameters

For trucks without a display instrument (CanDis (o)) the parameters must be

adjusted with particular care to avoid incorrect entries.

The following example shows the parameter setting for the acceleration of travel

program 1 (parameter 0256).

Acceleration example

– Enter the four-digit parameter number (0256) and confirm with the Set key (15).

– Enter the subindex “2” and confirm with the set key (15).

– Check the LC display of the display instrument (CanDis (o)) (parameter number

and current parameter value are displayed).

– Enter the parameter according to the parameter list and confirm with the Set key

(15).

– The LED (14) of the o key (19) switches briefly to a steady light and starts flashing

again after approx. 2 seconds.

– The parameter and subindex are displayed alternating with the entry 0256-2 <->

0000-5).

If the entry is incorrect, the LED (14) of the o key (19) flashes red. If you enter the

parameter number again the setting can be entered or changed.

Repeat the procedure to enter further parameters as soon as the LED (14) of the o

key (19) flashes. To complete your entry, press the o key (19).

Travel is disabled while the parameters are being entered. If the setting is to be

checked in programming mode, follow this sequence:

– Select the edited travel program after entering the parameter, and confirm with the

Set key (15).

– The truck is now in travel mode and can be checked.

– To continue setting, confirm with the Set key (15) again.

– Repeat the procedure to enter further parameters.

– When all the parameters have been entered, carry out the “SaveParameters”

function by pressing keys 1-2-3-Set.

– When you have finished entering the parameters, press the o key (19).