Jungheinrich ERE Series User Manual

1113.GB
E 16
5.4 Parameter Settings
To change the truck setting you must enter the master code.
Z
The factory setting for the master code is 7-2-9-5.
M
When starting the truck for the first time, change the master code (see Section 5.1).
F
Safety instructions for trucks with a display instrument (CanDis (o))
– Parameter settings must be made carefully and only by special trained personnel.
If in doubt, consult the manufacturer's service department.
– Every setting procedure must be monitored on the LC display of the display
instrument (o). If in doubt, the setting procedure must be cancelled by pressing the
o key (21).
– Since changing any parameter will affect the truck's travel pattern, you must carry
out a test run in a specially designated work area.
To enter the master code:
– Press the o key
– Enter master code
Code Lock Parameters
Setting procedure for trucks without display instrument (CanDis (o)):
– Enter the three digit parameter number, confirm with the Set key (17).
– Enter the setting according to the parameter list or change and confirm with the Set
key (17).
Z
If the entry is incorrect, the LED (16) of the o key (21) flashes red. If you enter the
parameter number again the setting can be entered or changed.
– To enter more parameters, repeat the procedure.
– When all the parameters have been entered, carry out the “SaveParameters”
function by pressing keys 1-2-3-Set.
– When you have finished entering the parameters, press the o button (21).
Display instrument
(CanDis)
LED (16)
o key
LED (18)
Key 1
LED (19)
Key 2
LED (20)
Key 3
Service hours
are indicated
284.0
Green
flashing
Off Off Off
1113.GB
E 16
5.4 Parameter Settings
To change the truck setting you must enter the master code.
Z
The factory setting for the master code is 7-2-9-5.
M
When starting the truck for the first time, change the master code (see Section 5.1).
F
Safety instructions for trucks with a display instrument (CanDis (o))
– Parameter settings must be made carefully and only by special trained personnel.
If in doubt, consult the manufacturer's service department.
– Every setting procedure must be monitored on the LC display of the display
instrument (o). If in doubt, the setting procedure must be cancelled by pressing the
o key (21).
– Since changing any parameter will affect the truck's travel pattern, you must carry
out a test run in a specially designated work area.
To enter the master code:
– Press the o key
– Enter master code
Code Lock Parameters
Setting procedure for trucks without display instrument (CanDis (o)):
– Enter the three digit parameter number, confirm with the Set key (17).
– Enter the setting according to the parameter list or change and confirm with the Set
key (17).
Z
If the entry is incorrect, the LED (16) of the o key (21) flashes red. If you enter the
parameter number again the setting can be entered or changed.
– To enter more parameters, repeat the procedure.
– When all the parameters have been entered, carry out the “SaveParameters”
function by pressing keys 1-2-3-Set.
– When you have finished entering the parameters, press the o button (21).
Display instrument
(CanDis)
LED (16)
o key
LED (18)
Key 1
LED (19)
Key 2
LED (20)
Key 3
Service hours
are indicated
284.0
Green
flashing
Off Off Off

Jungheinrich ERE Series Specifications

General

Brand	Jungheinrich
Model	ERE Series
Category	Compact Loader
Language	English