To Next Page

To Previous Page

C 1

0108.GB

C Transport and Commissioning

1 Lifting by crane

Only use lifting gear with sufficient

capacity (for truck weight see truck

data plate, chapter B).

Lifting gear attachment points (1) are

provided on the chassis and the fork in

case the truck is to be lifted or trans-

ported by crane.

– Park the truck securely (see

Chapter E).

– Secure the lifting gear to the

attachment points (1).

The lifting gear must be attached to the

attachment points in such a manner

that it cannot slip under any circum-

stances and cannot come into contact

with any attachments of the truck when

the truck is lifted.

2 Commissioning

Only operate the truck with battery current. Rectified AC current will damage the

electronic components. The battery leads (tow cable) must be less than 6m long.

To prepare the truck after delivery or after transport, proceed as follows:

– Check the truck for completeness and satisfactory condition of the equipment.

– Install battery (where required). Do not damage battery cable.

– Charge the battery (see Chapter D).

– If necessary, adjust the combination instrument to match the battery type (see

Chapter D).

111

C 1