Unpacking and Mounting the EX4650 Switch
IN THIS SECTION
Unpacking the Switch | 81
Parts Inventory (Packing List) for an EX4650 Switch | 82
Registering Products—Mandatory for Validating SLAs | 83
Mounting an EX4650 Switch on Four Posts of a Rack or Cabinet | 83
Unpacking the Switch
EX4650 switches are shipped in a cardboard carton, secured with foam packing material. The carton has
an accessory compartment and contains the quick start instructions.
CAUTION: EX4650 switches are maximally protected inside the shipping carton. Do not
unpack the switches until you are ready to begin installation.
To unpack the switch:
1. Move the shipping carton to a staging area as close to the installation site as possible, but where you
have enough room to remove the system components.
2. Position the carton so that the arrows marked on the carton are pointing up.
3. Open the top flaps on the shipping carton.
4. Pull out the packing material holding the switch in place.
5. Verify the parts received against the inventory on the label attached to the carton.
6. Save the shipping carton and packing materials in case you need to move or ship the switch later.
81
To Next Page
Loading...
Need help?
General