Juniper MX2020 User Manual

[edit]
root# set routing-options static route remote-subnet next-hop destination-IP retain
no-readvertise
7. Configure the telnet service at the [edit system services] hierarchy level.
[edit]
root#set system services telnet
Commit the Configuration
1. Display the configuration to verify that it is correct.
[edit]
root@# show
system {
host-name host-name;
domain-name domain-name;
backup-router address;
root-authentication {
authentication-method (password | public-key);
}
name-server {
address;
}
}
interfaces {
fxp0 {
unit 0 {
family inet {
address address/prefix-length;
}
}
}
}
2. Commit the configuration to activate it on the router.
[edit]
root@# commit
3. Optionally, configure additional properties by adding the necessary configuration
statements. Then commit the changes to activate them on the router.
[edit]
root@host# commit
4. When you have finished configuring the router, exit configuration mode.
[edit]
root@host# exit
root@host>
Copyright © 2015, Juniper Networks, Inc.66
MX2020 3D Universal Edge Router Quick Start

Juniper MX2020 Specifications

General

Slots	20
Operating System	Junos OS
Form Factor	Modular
Chassis Type	Modular
Weight (approximate)	600 lb (272.2 kg)
Supported Interfaces	10G, 40G, 100G
Routing Protocols	BGP, IS-IS, OSPF, RIP
Routing Engine	Dual Routing Engines
Power Supply	AC or DC
Power Supply Options	AC, DC

Summary

Prepare the Site for Installation

Rack-Mounting Requirements

Install the Mounting Hardware

Install the Router

Unpack the Router

Install the Router Using a Pallet Jack with Attachment

Procedures for installing the router with a pallet jack attachment.

Install the Router Using a Router Transport Kit

Procedures for installing the router using the router transport kit.

Connect the Grounding Cable

Connect External Devices and Line Card Cables

Connect to a Network for Out-of-Band Management

Connect Power Cables

Connect Power to a Three-Phase Delta AC Power Distribution Module

Procedures for connecting power to a three-phase delta AC PDM.

Connect Power to a Three-Phase Wye AC Power Distribution Module

Procedures for connecting power to a three-phase wye AC PDM.

Connect AC Power Supply Modules

Connect Power to a DC Power Distribution Module

Connect DC Power Supply Modules

Perform Initial Software Configuration

Enter Configuration Mode

Steps to enter the router's configuration mode via CLI.

Configure User Accounts and Passwords

Configure System Attributes

Safety Warnings

Compliance Statements for NEBS

Compliance Statements for EMC Requirements