Mounting
Page Operating Instructions for Powador .-. TL_EN
ENEN
Authorised electrician
. Unpacking
Figure : Unpack device/ transport device
Key
1 Cardboard box cover 4 Cover
2 Protective corners 5 Eyebolts
3 Pallet
Unpacking the unit
. Loosen packaging tape from cardboard box.
. Lift down the cardboard box cover.
. Remove protective corners.
. Remove the cover.
. Install and secure
WARNING
Impact hazard, risk of breakage to the inverter
› Pack the inverter securely for transport.
› Carefully transport the inverter using the built-in eyebolts!
CAUTION
Risk of injury if the inverter tips over!
Risk of tipping due to high centre of gravity, particularly with the housing doors open.
› Anchor the inverter securely to the ground immediately after positioning it and, if possible, fasten
it to the wall.
› Do not open the housing doors until the inverter has been securely anchored.
To Next Page
Loading...
Need help?
General