KEB COMBIVERT F5 Instructions For Use

9 Certication
9.1 CE Marking
CE marked drive converters and servo drives were developed and manufactured to
comply with the regulations of the Low-Voltage Directive and EMC Directive.The harmo-
nized standards of the series EN 61800-5-1 and EN 61800-3 were used.
For more information about the CE declarations of conformity.
=> Further informations and documentation.
9.2 UL Marking
Acceptance according to UL is marked at KEB drive converters
with the adjacent logo on the nameplate.
To be conform according to UL for the use on the North American and Canadian Market
the following instructions must be observed (original text of the UL):
•
Control Board Rating (max. 30 Vdc, 1 A)
•
„Maximum Surrounding Air Temperature 45°C“
•
Degree of Overload Protection provided internally by the Drive, in percent of full
load current.
•
Devices are intended for use in pollution degree 2 environment
•
Wiring Terminals marked to indicate proper connections for the power supply, load
and control circuit.
•
„Use 75°C Copper Conductors Only“
•
Terminals - Torque Value for Field Wiring Terminals, the value to be according to
the R/C or Unlisted Terminal Block used.
•
Input/Output connections - „Input/output Studs/Nuts shall be connected with UL List-
ed Ring Connectors (ZMVV/ZMVV7) rated 600 V and suitable ampere rating (min.
125 % of Input/Output Currents).The tightening torque value of the Nuts needs to be
310 lb-in. (35 Nm)”
•
Integral solid state short circuit protection does not provide branch circuit protec-
tion. Branch circuit protection must be provided in accordance with the Manufactur-
er Instructions, National Electrical Code and any additional local codes.
•
These devices do not incorporate an internal solid state motor overload protection
and are intended to be used with motors having thermal protectors in or on the mo-
tors.
92
CERTIFICATION

KEB COMBIVERT F5 Specifications

General

Brand	KEB
Model	COMBIVERT F5
Category	DC Drives
Language	English