15-2 Disassembly
Introduction
This section explains how to handle, clean, and disassemble the Model 2306 — drawings are
located at the end of this section.
WARNING The procedures in this section are intended only for qualified service personnel.
Disconnec
t the line cord and all test leads and wires from the instrument before
disassembling the unit.
Handling and cleaning
To avoid contaminating PC board traces with body oil or other foreign matter, avoid touching
the PC board traces while you are repairing the instrument. Some circuit board areas have high-
impedance devices or sensitive circuitry where contamination could cause degraded
performance.
Handling PC boards
Observe the following precautions when handling PC boards:
• Wear cotton gloves.
• Only handle PC boards by the edges and shields.
• Do not touch any board traces or components not associated with repair.
• Do not touch areas adjacent to electrical contacts.
• Use dry nitrogen gas to clean dust off PC boards.
Solder repairs
Observe the following precautions when soldering a circuit board:
• Use an OA-based (organic activated) flux, and take care not to spread the flux to other
areas of
the circuit board.
• Remove the flux from the work area when you have finished the repair by using pure wa-
ter with clean, foam-tipped swabs or a clean, soft brush.
• Once you have removed the flux, swab only the repair area with methanol, then blow dry
the
board with dry nitrogen gas.
• After cleaning, allow the board to dry in a 50°C, lo
w-humidity environment for several
hours.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
