To Next Page

To Previous Page

1-10 Getting Started

Display modes

For voltage and current readings, there are four display modes described as follows:

• ACTUAL V AND I — This

display mode is used to read back the actual output voltage

and current. This display mode is the RST default. (See Section 2 for details.)

• DVM INPUT — This mode is used to

display the DC voltage applied to the DVM input

of the power supply. (See Section 2 for details.)

• PULSE CURRENT — This

mode is used to display high, low, or average pulse-current

measurements. (See Section 3 for details.)

• LONG INTEGRATION — This mode

is used to display average current measurements

of a pulse or pulses measuring periods between 850msec to 60sec (60 Hz line frequency)

and 840msec to 60sec (50 Hz line frequency). (See Section 4 for details.)

Any one of the four display modes can be the power-on default. Use the SAVE SETUP item

of the

MENU to save the selected display mode in memory, and use the POWER ON SETUP

item to specify the power-on setup (see “Setups — Save, Power-on, and Recall” on page 1-14

for details). A display mode is selected as follows:

1. Press the DISPLAY key and use the

▲ or ▼ key to display the desired mode: ACTUAL

V AND I, DVM INPUT, PULSE CURRENT, or LONG INTEGRATION.

DISPLAY TYPE #1 or DISPLAY TYPE #2 will be shown on the top line of the display.

NOTE DISPLA

Y TYPE #1 is the display mode for the Battery Channel while DISPLAY TYPE

#2 is the display mode for the Charger Channel.

2. Toggle active channel using the

▲

keys.

NOTE If activ

e channel is changed back to the original channel, the initial settings are

displayed.

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176

TestEquipmentDepot.com

Keithley 2306 User Manual

Other manuals for Keithley 2306