= Removing the hook cover plate .
(_ Hook cover plate release button
(_ Hook cover plate
Slide the hook cover plate release buttonQto the right,
and remove the cover plate (_.
Inserting the bobbin
_) End of thread
(_ Notch
(_ Notch
@ Threading diagram
[] Place a bobbin in the bobbin holder with the thread
running off counterclockwise,,
[] Guide the thread into notch (_on the front side of
the bobbin holder, Draw the thread to the left, sliding it
between the tension spring blades
[] Continue to draw the thread lightly until the thread slips
into notch (3"_oPull out about 6" (15,,0 cm) of thread
[] Attach the hook cover plate rCheck the threading by
referring to the diagram@shown on the hook cover plate.
[]
[]
@
[]
.J
....... J
26
To Next Page
Loading...
Need help?
General
