To Drop or Raise the Feed Dogs
The drop feed dogs lever is located underneath the free
arm bed on the back side of the machine..
(_ To drop the feed dogs, push the lever in the direction
of the arrow, as illustrated.
(_) To raise the feed dogs, push the lever in the direction
of the arrow, as illustrated, and turn the handwheel
toward you Feed dogs must be up for normal sewing.
fl
®
fl
®
Darning
(_ Stitch selector: 6 to 8
(_) Stitch width: 65
Stitch length: Any
(_ Needle thread tension: 2 to 6
_._Pressure adjusting lever: 0
(_ Presser foot A: Zigzag foot
(_ Presser foot F: Satin stitch foot
(_) Feed dogs: Dropped
Drop the feed dogs,. Center the hole in the fabric on an
embroidery hoop, as shown,
Lower the presser foot F and sew at a stow speed,
Move the fabric back and forth slowly until the darning area
is covered,. Turn the fabric 1/4 turn (90°), and sew another
layer of stitching over the first layer.. After darning is
completed, return the pressure adjusting lever to 3 for
normat sewing.
NOTE:
If the fabric is thin or badly damaged, use a separate
piece of fabric under the hole to reinforce it,
f
@
1 I i
t I I
( L?J}®
_ou "_-.3J --
®
J
.J
\
50
To Next Page
Loading...
Need help?
General
