Kodak ESP 3 User Manual

Product overview
User guide 5
USB port
You can use the USB port on the front panel of the Kodak ESP 3 All-in-One printer to connect a
PictBridge camera and print pictures directly from the camera. The Kodak ESP 3 All-in-One printer
can access images from most digital cameras.
You can also use the USB port to access pictures on a USB device, such as a thumb drive, and
transfer them to your computer.
Status lights
The following provides information on the Kodak ESP 3 All-in-One printer status lights.
Control panel
Light status
Cause
Action/Solution
The printer is turned off.
Press On/Off to turn the printer on.
All lights and displays
are off.
The printer does not have power
applied.
Ensure that the power lead is
properly plugged into the back of the
printer.
All lights flash once.
The printer is initialising.
None. Allow the printer to finish the
initialisation process.
All lights are flashing
and the On/Off light is
flashing amber.
The printer has detected an error
condition.
Disconnect power for 5 seconds and
reconnect power. If the condition
persists, contact Kodak for
assistance.
Check Colour Ink light
Light status
Cause
Action/Solution
Check Colour Ink
light is off.
Normal operation. This light
should be off when a colour ink
cartridge has been properly
installed and has enough ink to
print.
None.
Check Colour Ink
light is flashing
red slowly.
The colour ink cartridge ink level
is low.
Check the ink level in the Home
Centre or on the Printer Status
Monitor (Windows).
Check Colour Ink
light is flashing
red rapidly.
The colour ink cartridge needs
attention.
Ensure that the colour ink cartridge is
installed properly.

Kodak ESP 3 Specifications

General

Brand	Kodak
Model	ESP 3
Category	All in One Printer
Language	English