EasyManuals Logo
Home>Kodak>All in One Printer>ESP 3

Kodak ESP 3 User Manual

Kodak ESP 3
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
Chapter 8
52 Kodak ESP·3 All-in-One
Print too dark
Try retaking the picture with the flash on or move within the flash range of the camera. Refer to
your camera's user guide for details.
Adjust the exposure compensation on your camera and try taking the picture again. Refer to
your camera's user guide for details.
Edit the picture using Kodak Home Centre or Kodak EasyShare software on your computer.
Refer to the EasyShare software Help for details.
Make sure the printer is not placed in direct sunlight and is not operating in a high-temperature
environment.
Print too light
Important For best results, use Kodak ink cartridges and paper for your printer.
Make sure the paper is loaded with the Kodak logo facing up. Reload if necessary.
Try taking the picture again with the flash off. Refer to your camera's user guide for details.
Adjust the exposure compensation on your camera and try taking the picture again. Refer to
your camera's user guide for details.
Edit the picture using Kodak Home Centre or Kodak EasyShare software on your computer.
Refer to the Home Centre or EasyShare software Help for details.
Printing slow
Note When printing a large number of prints, printing may slow down to prevent the printhead
from overheating.
Make sure the printer is not placed in direct sunlight and is not operating in a high-temperature
environment (higher than 35° C or 95° F).
Close unnecessary software applications.
Make sure your computer meets the minimum system requirements. Upgrade your system if
necessary
Printing stops
Printing stops mid-print. Paper stops feeding and Status light may blink.
Important For best results, use Kodak ink cartridges and paper for your printer.
To check the paper
1 Remove any loose paper from the printer. Check the paper access door in the rear of the
printer.
2 Inspect the paper supplies and reload with new paper, if necessary.
3 Carefully "fan" the paper to keep the sheets from sticking together.
4 Reload the paper tray. Do not overload.
5 Press Copy to continue or Cancel to stop

Table of Contents

Other manuals for Kodak ESP 3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kodak ESP 3 and is the answer not in the manual?

Kodak ESP 3 Specifications

General IconGeneral
BrandKodak
ModelESP 3
CategoryAll in One Printer
LanguageEnglish

Related product manuals