Kodak ESP 3 User Manual

Chapter 8
44 Kodak ESP·3 All-in-One
Device not recognised
Probable cause
Any of the following can prevent your Kodak printer from reading a connected digital camera, USB
thumb drive or memory card.
 The camera is turned OFF.
 More than one memory card inserted.
 The USB connector from the camera is not fully inserted in the port.
 The memory card is not completely inserted.
 The memory card is in backwards.
 Make sure camera is in connect mode (PTP)
 The memory card file system is corrupt.
 The USB device is not supported.
Corrective action
 Correct any connection problems and try again.
 If the memory card file system is corrupt, reformat it in your camera.
 Disconnect the unsupported device.
Ink cartridge not recognised
Probable cause 1
Generic or non-Kodak ink cartridges may not function in the KODAK EASYSHARE All-in-One
Printer. Kodak recommends using Kodak ink cartridges.
Corrective action
Install a genuine Kodak ink cartridge.
Probable cause 2
One of the ink cartridges has expired and needs to be replaced.
Corrective action
Replace the expired ink cartridge.
Multiple paper feed
Probable cause
Multiple sheets of paper were pulled through printer.
Corrective action
1 Remove the paper from the paper tray.
2 Carefully "fan" the paper to keep the sheets from sticking together.
3 Reload the paper tray. Do not overfill.
4 Press Copy to continue or Cancel to stop.

Kodak ESP 3 Specifications

General

Brand	Kodak
Model	ESP 3
Category	All in One Printer
Language	English