TP-7070 7/18 15Section 1 Specifications and Features
Section 1 Specifications and Features
1.1 Introduction
The spec sheets for each generator set provide model-
specific generator and engine information. The
controller spec sheet provides specifications for the
controller. Refer to the respective spec sheet for data
not supplied in this manual. Refer to the generator set
service manual, installation manual, engine operation
manual, and engine service manual for additional
specifications.
1.2 Controller Specifications
1.2.1 Con t roller Specifications
D Power Supply Requirements:
d Nominal voltage: 24 VDC, reverse polarity
protected
d 240 VAC/60Hz customer-supplied; factory wiring
to basic electrical package available
D Operating Temperature:
-- 4 0 _Cto70_C(--40_F to 158_F)
D Storage Temperature:
-- 4 0 _Cto70_C(--40_F to 158_F)
D Humidity: 5% to 95% non-condensing
D Protection Index:
d IP65 Front
d IP20 Rear
D Standards:
d NFPA 99
d NFPA 110, Level 1
d CSA 282-09
d UL 508
d IEC/EN60068-2-52 (salt spray)
d CE Directive
1.2.2 Display and Touchscreen
D Type: XGA TFT LED LCD
D Screen Size: 305 mm (12 inches)
D Viewing Angle: 140_ horizontal and vertical
D Languages: English, French
Note: Have setup and adjustments of the controller
performed only by an authorized Kohler
distributor. The setup and adjustments are
password protected.
1.3 Controller Features
The controller features include a 307 mm (12.1 inch)
touchscreen with backlight and wide viewing angle (140
degrees horizontal and vertical) and terminal blocks for
input and output connections. See Figure 1-1 for an
illustration of the controller front panel and the customer
connection area. Controller features include:
D 12-inch touchscreen with backlight and wide viewing
angle for easy local access to data.
D System settings are password-protected.
D Measurements selectable in metric or English units.
D User language is selectable (English or French).
D Graphic displays show generator set mechanical
values including operating hours, fuel level*, battery
voltage, coolant temperature, oil pressure, and oil
temperature.
D Meter displays provide a visual representation of
generator electrical values including power (kW),
power factor, reactive power (kVAR), frequency,
voltage, and current (amps).
D Two USB ports allow connection of a flash drive,
mouse, or keypad.
D Electrical data, mechanical data, and system settings
can be saved to a flash drive.
D Recording feature allows data collection of key
values.
D Ethernet port allows connection to a PC type
computer and/or Ethernet switch.
D Serial (RS-485) port.
D The controller supports Modbusr RTU and TCP
protocols.
D Real time clock with battery back-up.
D See the controller specification sheet or operation
manual for input and output specifications.
Modbusr is a registered trademark of Schneider Electric.
* Where applicable
To Next Page
Loading...
Need help?
General