Making copies
4
bizhub 160/161 4-5
4.2 Paper selection
The tray containing the paper you want to use can be manually selected. if
an optional paper feed unit is installed
When the desired paper is loaded into the bypass tray and the paper size and
type are specified, paper loaded into the bypass tray is given priority during
feeding.
Selecting the paper tray manually
Before selecting the paper tray manually:
0 If paper is loaded into the bypass tray, first remove it.
0 If tray 1 is selected, the paper size and paper type must first be specified.
For details, refer to “Selecting the PAPER SOURCE SETUP menu” on
page 5-11.
1 Position the original.
For details, refer to “Loading originals” on page 3-25.
2 Press the [Paper] key until the tray
loaded with the desired paper is se-
lected.
3 Specify the desired copy settings.
For details, refer to “Making a basic
copy” on page 4-3.
4 Using the 10-key pad, enter the
number of copies to be made, and
then press the [Start] key.
This will start the copy cycle.
4980P551DA
LT
2
To Next Page
Loading...
Need help?
General
